This page must be viewed with IE4 or above, and with Active Scripting enabled.
TAP SWITCHES NOTES/NAMEPLATES/CONNECTION DIAGRAMS NAMEPLATE DRAWINGS SERIES/PARALLEL CONNECTION DIAGRAM FIG. 1 FIG. 7 PARALLEL FIG. 2 FIG. 8 FIG. 3 FIG. 9 FIG. 4 FIG. 10 FIG. 5 FIG. 11 FIG. 6 FIG. 12 SERIES NOTES 1. Mechanical Release - Pull pin before operating main handle (* 1-SPDT auxiliary switch included with mechanism - 15A at 480VAC) 2.    1-SPDT Auxiliary Switch, contacts change in first 10° of handle motion.  15A at 480VAC 3. Customer Note: To install switch, remove (8) 3/8-16 hex head cap screws from side of angle frame. Remove subplate assembly from angle frame, insulated driver should be removed from first deck rotor with subplate assembly (keep adjustable stops in proper position). Caution: Do not remove adjustable stops from subplate assembly when removing subplate assembly from switch.  Place subplate assembly on front of customer mounting panel and bolt in place with 8 bolts.  Place switch behind customer mounting panel and bolt (8) 3/8-16 hex head cap screws in angle frame.  Care should be exerted to completely line switch up to prevent unnecessary binding of assembly.  Install rear support to back of switch support angles.